How to wrap?
First, be sure to wipe the unit clean with the cleaning wipe provided.
If you apply the skin sticker with dirt remaining, it will peel off easily.
Attach the skin sticker to the camera base and ring.
Remove the skin sticker from the main unit, place it upside down, and remove the logo mark part. Since it is pre-cut, it can be removed by pressing it with a thin, sharp object. Please note that it is not possible to remove only the logo part after it has been attached to the device.
a. How to attach the integrated type
Peel off the skin sticker from the base paper and align the four corners (pink areas) so that the margins are even.
Warm the side skin sticker crease and the area around the camera (pink area) with warm air from a hair dryer, and when the skin sticker is soft enough, apply it. If the skin sticker is not warmed enough, it will be lifted.
-If the skin sticker starts to float around the camera, apply it to the skin sticker.
If the skin sticker starts to float around the camera, apply warm air from a hair dryer to the skin sticker to make it adhere more strongly.
b. 分離型の貼り付け方
Peel off the skin sticker from the backing paper and align the four sides (orange areas) so that the margins are even.
-Crimp the skin sticker by applying warm air around the camera and pressing firmly.
Apply warm air from a hair dryer around the camera and press firmly to crimp.
Peel off the side skin stickers from the backing paper and apply them in the following order: bottom, left, right, and top.